Brendan Clarke is currently an R&D Engineer at Tescan Brno. He received his PhD in Opto-electronic Physics at the University of Southampton. A former recording engineer and technical director of KMA Music, New York, his interests include Physics, Engineering, Music Technology, and motorcycles.
EMAIL: He can be emailed directly at ‘bc’ at this website.
Thanks for visiting the site and feel free to get in touch!
Are the original .SND kits available?
hey
installed the firmware this afternoon to my lxr version 1 and it kept on crushing or freezing about 6-7 time in the span of an hour.
any similar experiences? and suggestions ?
thank you.
please contact me for some discussion. thanks
Hi Brendan
hope your well , im trying to play my lxr on drum pads , i would like to know how i can play the individal sounds on each pad example drum1on the kik drum ,snare 1 on the snare pad etc as all that happends is ony one sound plays all over the pads and and not the individal sounds on different pads
could help me ?
mant thanks
nath
Hi Nathan! There are a couple of different ways to do this, I think. You can either assign a different MIDI note to each voice, or a different channel. It will depend on the pads you are using which channels and note numbers will be best. Good luck!
Hi!!! I enjoy the 0.37 firware a lot!! Does the 0.37 works with Bastl’s 60 Knobs? Thanx!!
btw i think mpc and lxr is a nice combo. your vid is the best example!
hi,
i found your website an your videos on youtube. great stuff!
one question, sir: how do you connect and midi sync the lxr and the mpc?
thanks.
Hi!
Glad you enjoyed them 🙂 The MPC is acting as the MIDI master and the LXR is slaved. The LXR has to be set to BPM 0 and the rx filter has to be set to something with an ‘R’ in it (for realtime). The MPC I think has to be set to ‘Master’ in the ‘Sync’ options. They can be directly connected, but I tend to run things through a MOTU micro express – a huge headache saver for MIDI – when I’m at home. The MPC1000 is a great sampler/sequencer for sure! I’ve switched to an Octatrack for now, but the decision was almost entirely based on it having more audio inputs :D. Not that I’m complaining about the other stuff though!
hey, i´m working in a similar project as you did with the midi shield.
i would need some help with that. well i might have a little budget for that. let me know if you´re interested.
cheers
terence